Electroforce EFC39 – Programable Mobile Controller
Here is the perfect design: Electroforce EFC39 Control Unit! …..
EFC39 has been developed for professional use with ATMEL ATMEGA2560 chip. Arduino Sketch can be programmed with the standard Arduino Mega option, or the Atmel Studio can be programmed without using Arduino firmware on the ATMEGA2560 chip.
With the built-in CANBUS automotive applications can be improved.
There are 2 voltage outputs which can be set by software in zero volt to supply voltage range. If you need a digital potentiometer, you can use these outputs.
There are 2 models available as Basic and Full.
10 analogue inputs, 4 digital low active inputs, 10 2A DC PWM outputs, 2 0-32V analogue outputs, 1 5V sensor feedout outputs, 4 inputs for automotive applicationsThe CanBUS port has one Serial TTL port, which you can use to load parameter settings and software.
In Basic mode, there are 10 0-32V analog inputs, 4 digital low active inputs, 10 2A 2A PWM outputs, 1 5V sensor feedout output, and 1 serial TTL.